CANopenî and, ( IPEH-002021 ) and Figure 3 shows the positions of the solder field R11 on board of the PCAN-USB, Figure 2: PCAN-USB board ( IPEH-002021 ), solder field JP3 5-Volt supply â None Pin 1 Pin 9 Text: PCAN-USB USB to CAN Interface User Manual V2.1.3 PCAN-USB â User Manual Product Name Model Part Number PCAN-USB PCAN-USB opto-decoupled IPEH-002021 Galvanic isolation for CAN interface IPEH-002022 The cover picture shows the product PCAN-USB opto-decoupled. 5-Volt supply to the CAN connection can be connected through a solder jumper, e.g.IPEH-002021 Datasheets Context Search Catalog Datasheet.Induced error generation for incoming and outgoing CAN messages.Measurement of bus load including error frames and overload frames on the physical bus.CAN termination can be activated through a solder jumper.FPGA implementation of the CAN FD controller.CAN bus connection via D-Sub, 9-pin (in accordance with CiA® 303-1).CAN bit rates from 25 kbit/s up to 1 Mbit/s.CAN FD bit rates for the data field (64 bytes max.) from 25 kbit/s up to 12 Mbit/s.CAN FD support for ISO and Non-ISO standards switchable.Complies with CAN specifications 2.0 A/B and FD.High-speed CAN connection (ISO 11898-2).Adapter for High-speed USB 2.0 (compatible to USB 1.1 and USB 3.0).If you are interested and for further information, please contact assignment D-Sub Devices delivered until February 2015 need a firmware update for this functionality. If required, the user can switch to the CAN FD protocol used in the environment by software („Non-ISO“ and „ISO“). PEAK-System takes this into account by supporting both protocol versions with their CAN FD interfaces. The revised CAN FD standard is not compatible with the original protocol. Since the first implementations of CAN FD, the protocol has been improved and is now included in the standard ISO 11898-1. The monitor software PCAN-View and the programming interface PCAN-Basic for the development of applications with CAN connection are included in the scope of supply and support the new standard CAN FD. However, in this case the CAN FD extensions are not applicable. CAN FD is downward-compatible to the CAN 2.0 A/B standard, thus CAN FD nodes can be used in existing CAN networks. The maximum of 64 data bytes per CAN FD frame (instead of 8 so far) can be transmitted with bit rates up to 12 Mbit/s. The new CAN FD standard (CAN with Flexible Data rate) is primarily characterized by higher bandwidth for data transfer. The simple handling and its compact plastic casing make the adapter suitable for mobile applications. A galvanic isolation of up to 500 Volts decouples the PC from the CAN bus. The CAN FD adapter PCAN-USB FD allows the connection of CAN FD and CAN networks to a computer via USB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |